Crestron Control Information Logic Input and Output Controls See below for a sample screen. SIMPLWINDOWS NAME: Aspi Vortex Logic Inputs+Outputs MANUFACTURER: Polycom MODEL: Vortex EF2280 CATEGORY: MIXER VERSION: 1.0 SUMMARY: Allows all of the logic inputs and outputs to be monitored. GENERAL NOTES: The commands used for the Polycom Vortex may be similar to commands used for other Polycom Installed Voice products. Therefore, the same modules developed for the Vortex may work on other products. To allow for this flexibility of use, you must specify which model is being controlled using the TYPE-ID-HEX parameter field. This must be a 2 digit hex representation of the model type as defined by Polycom. For the Vortex, the model type is F, therefore the parameter value to use is 46 which is the hex representation of the letter F. This can be seen by checking any standard ASCII chart. There should be no suffix used after the 46. Multiple devices can be connected to the ASPI bus and controlled from a single RS232 port. Therefore, it is also necessary to enter the Unit ID of the device being controlled. This should be entered in the UNIT-ID-ASCII parameter field as a two digit number from 00-07 with no suffix. This module allows the automatic reporting of logic input/output states to be enabled/disabled. If the automatic status is disabled, you can use the POLL input to manually poll the status. The state of the logic inputs/outputs will be reflected at the INPUT-*-ON and OUTPUT-*-ON outputs. CRESTRON HARDWARE REQUIRED: CNXCOM, ST-COM SETUP OF CRESTRON HARDWARE: Baud Rate - 9600 Parity - None Data Bits - 8 Stop Bits - 1 RTS/CTS Handshaking should be enabled to insure no data is lost. VENDOR FIRMWARE: 1.15 VENDOR SETUP: Ack mode must be set to "on" CABLE NUMBER: CNSP-141 INPUT DESCRIPTIONS: Name Type Description ENABLE/DISABLE-AUTO-UPDATE D Pulse to enable or disable the automatic reporting of the input or output logic status. POLL D Pulse to manually poll the logic status. This should not be needed if automatic reporting has been enabled FROM-ASPI-PROCESSOR$ S Must be routed from the output of the Vortex Feedback Processor module TYPE-ID-ASCII P Enter 46 for Vortex UNIT-ID-ASCII P Enter the unit number of the Vortex. Should be a number from 00-07 OUTPUT DESCRIPTIONS: Name Type Description INPUT-*-ON D True feedback indicating which logic inputs are on ASPI-TX$ S Serial signal to be routed to a 2-way RS232 port OPS USED FOR TESTING: 5.12.26x COMPILER USED FOR TESTING: SimplWindows Ver 1.61.12 SAMPLE PROGRAM: Vortex Demo Program REVISION HISTORY: None Gating and Camera Gating Controls Macro and Preset Controls Line Level Input Controls Mic Input Controls Output Controls Crestron Website Back to Main Page | Contact Us Products | Technical Resources | More About Us Polycom Installed Voice Business Group 1720 Peachtree St NW, Suite 220 Atlanta,GA 30309 telephone: 404.892.3200 fax: 404.892.2512 e-mail us